Share
The newly designed H4537 vertical vise works with the company's Fixturing System 4000. The vise provides quick and positive clamping of one or two independent workpieces in the same setup with twice the holding strength of similar devices, the company says.
Two separate clamping jaws require only the turning of a central screw for tightening. No supporting spacers or jackscrews are needed as with toe-clamp type devices, according to the company. The clamping jaws were designed for minimal obstruction above the top of the workpiece.
The clamping jaws have two workpiece height ranges, 0 to 21 mm and 21 to 41 mm. The latter clamping height is achieved by removing the clamping jaws and re-inserting them upside down. Also available are optional height-extending clamping jaws that extend the clamping range up to 41 to 61 mm.
Removable positive side stops are standard on both sides of the vise for quick alignment of repetitive workpieces.
Related Content
-
Wall Colmonoy Acquires New Wire EDM From Sodick
The company will use the new wire EDM machine to increase capacity, improve cycle times, achieve tighter tolerances and improve surface finishes.
-
EDM, Laser Micromachining and More at GF Medical Demo Center
At GF’s Medical Center of Competence, the company shows off EDM and laser features that could make a large impact on medical manufacturing — and elsewhere.
-
GF Machining Solutions Celebrates 70 Years of EDM Technology
GF Machining Solutions is celebrating the 70th anniversary of its discovery of EDM Technology.