Tooling
More Effective Deep-Hole Drilling with MQL
A dual-margin design enables a series of drills from Nachi to create holes with large length-to-diameter ratios with minimum quantity lubrication.
Read More
Rough Boring Tool Cuts Challenging Material, Time in Aerospace Application
By using Sandvik Coromant's DuoBore 821D rough boring tool, Excelco/Newbrook Inc. increased feed rates and saved shop production time cutting Nitronic 40 for aerospace work.
Read More
Surface Finishing System Shortens Cycle Times
Rosler’s Surf finishing machine uses an automated surface finishing process designed for deburring, surface grinding, smoothing and polishing of components with complex geometries.
Read More
Standardized Parameters Make Unattended Machining Reliable
Standardized parameters for specific material and cutting tool combinations help this hard milling specialist manage a highly varied workload with minimal labor.
Read More
Contour-Following Stylus Speeds Dot-Peen Marking
Capability to mark surfaces at widely varying heights and difficult-to-reach areas makes pneumatic systems more competitive by reducing the need for special fixtures and other accessories.
Watch
Video: Efficiency on Tap
The Softsynchro 0 Tap Holder from Emuge handles new tap ranges and has been shown to significantly increase tool life in a rigid tapping environment.
Watch
Video: Flat-Bottom Drill Versus Conventional
See how a flat-bottom drill tends to shear material as it exists the back side of a workpiece, leaving behind a minimal burr.
Watch
PCD-Tipped Milling Insert Grades Improve Surface Quality
Seco Tools has introduced two new PCD-tipped milling insert grades, the PCD05 and PCD20, for use with its Turbo 10 cutters.
Read More
Tool Holds Parallels in Place
Rimeco Products’ ParaKeep—short for Parallel Keeper—is designed to be used with any standard set of parallels on any machine vise.
Read More
Collet System Avoids Cutter Pull-Out in High-Feed Applications
Pioneer has developed a cost-effective collet system for high-feed applications in which cutters pull out from their holders.
Read More