Milling Tools
Why Do Cutting Tool Charts Give Recommended Parameters in a Broad Range?
The answer has to do with the differences from cut to cut, as well as the differences that make some shops more capable than others.
Read More
Sponsored Video: Helically Interpolating a Hole at 225 IPM Through a Milled Slot
This video demonstrates Dapra's 1" Toroid End Mill executing the helical interpolation of a 1.75" diameter hole to a depth of 1.25". The material is H13, and the machine tool used is a Fadal 4020 with a 40-taper spindle.
Watch
Catalog Features Tools For Increased Productivity
The 2010 full-color catalog from Imco Carbide Tool features case studies and user testimonials that include tips for increased productivity, sustained performance and extended tool life.
Read More
Tool for Shallow, High-Feed Cuts Speeds Roughing
“Feed fast, cut shallow.” This strategy, in combination with a cutting tool specifically designed to take advantage of it—the Power Feed+ from Ingersoll—enabled this shop to reduce cycle time on a tough prototyping job by a factor of five and increase insert life by a factor of six.
Read More
When Spindle Speed is a Constraint
Though it won’t replace high speed machining, Boeing sees “low speed machining” as a viable supplement to higher-rpm machines. Using new tools and techniques, a shop’s lower-rpm machining centers can realize much more of their potential productivity in milling aluminum aircraft parts.
Read More
Video: Getting the Most Out of Your Standard Spindle
High spindle speed is not needed for high productivity, particularly with the right choice of cutting tool types. Techniques described in this tutorial video relate to plunge roughing, high feed milling and slotting.
Watch
Video: Plunge Roughing in Aluminum
Even in aluminum, plunge roughing can be an effective way to realize high productivity.
Watch
Video: High Feed Milling in Aluminum
Footage shows roughing at 48 cubic inch per minute on a standard-speed machining center.
Watch
Coated End Mills Increase Tool Life
OSG Tap & Die’s Exocarb WXS end mills are designed for milling 54 to 70 HRc at high speeds.
Read More
Dial Down or Dial Up?
Vibration analysis may be the machining center’s missing piece. If you haven’t performed this analysis on your high speed machine, you probably don’t know what the machine can do.
Read More